NEWS CENTER

Home page

Teach yourself how to install smart toilet seats

Category： News and information

2023-10-13 13:40

As the saying goes, do you have to wait for a professional installer to handle the high-end smart toilet seat, as you can get enough food and clothing by doing it yourself? Below, the editor will provide a detailed picture tutorial to help you learn how to install a smart toilet lid on your own in ten minutes.

教你自己安装智能马桶盖

Firstly, prepare all necessary accessories and tools for installation to facilitate installation. Remove the original cover plate and seat ring from the toilet, store the components, and prepare for fixing work. Find the card plate, align it with the two holes on the toilet, adjust the distance, and fix the card plate on the toilet with fixing bolts and nuts.

There is a square slot at the bottom of the smart toilet cover, align it with the just fixed card plate on the toilet, gently push it in, make sure to push it in place, otherwise the toilet cover will shake left and right.

Our installation of the smart toilet seat cover is halfway done, isn't it very simple. The next step is to install the filter. Before installation, be sure to close the water supply valve and drain all the water in the toilet water tank.

Separate the inlet pipe of the toilet water tank from the water valve, and then connect and tighten the three-way joint with the water valve. The remaining two joints are connected to the inlet pipe of the toilet water tank and the filter of the three-way joint. Kick it off! Clean water filter out! This step is very simple, just connect the filter directly to the water inlet of the body cleaner! But make sure to tighten it!

Finally, screw the two ends of the water inlet hose on the smart toilet cover together with the three-way connector filter and the clean water filter, and you're done!

After connecting the pipeline, plug in the power supply, open the water supply valve, and perform product debugging to see if there are any leaking parts.

Previous： How to install the smart toilet seat cover

Next： No more!

RELATED INFORMATION

How to disassemble the smart toilet seat cover

To disassemble a smart toilet, turn off the power and water sources first Before opening the smart toilet lid, turn off both the power and tap water, and then use a screwdriver to unscrew it. The outer nut can be easily unscrewed, while the inner nut is close to the water tank and gropes in the direction of the water tank. Finally, all screws are unscrewed. Grasp both sides of the lid with your hand and gently pull it to remove it. 2. Find the nut, remove it with a moving hand, and then replace it with a new one. Ordinary nuts are difficult to find, some are in the open and some are in the dark. In a dark place, on the side near the sink in the toilet, usually installed next to the sink in the toilet, open the lid. Put your hand in and feel up and towards the water tank, you can feel it.

View Details